Freedom9 KVM-02 - Manual (Page 5)

5
Windows 98/98SE users: (KVM-02U)
When you use Windows 98/98SE with the USB KVM Switch (KVM-02U), please
use the following set up procedures:
1st Step:
1. Connect KVM USB type A cable to PC.
2. Connect KVM HDDB15 pin Male video cable to PC.
3. Make sure VGA monitor's cable is connected to console VGA port.
4. Connect PS/2 or USB keyboard to PC PS/2 keyboard or USB port directly.
Please do not connect PS/2 mouse or USB mouse to your PC.
5. Start up PC. The PC will be unable to find the mouse; the Windows O.S.
will show the following message or similar :
Windows did not detect a mouse attached to the computer. You
can safely attach a serial mouse now. To attach a mouse to a
PS/2 mouse port, you must first turn the computer off.
Do not show this message in the future.
Please use keyboard "Tab" key, "Space" bar and "Enter" key to select the
item
"
Do not show this message in the future." And finish booting Windows
O.S..
6. This will mount the USB HID (Human Interface Device) driver that the
Windows OS uses for USB mouse and keyboard support. Use Keyboard
Tab key, Left Arrow key, Right Arrow key and Enter key to complete set up
process.
7. Now install the next PC port of the USB KVM switch.
8. Repeat procedure item 5 and 6 to remaining PC.
9. Please use Windows to shut down computers.
2nd Step:
1. Connect PS/2 or USB keyboard and PS/2 or USB mouse to USB KVM
Switch's console port.
2. Turn on all PCs.