Friedrich MW09Y1F - Manual (Page 10)

En-9
ADJUSTING THE DIRECTION OF AIR CIRCULATION
Vertical (up-down) direction of airflow is adjusted by pressing the Remote Control Unit’s SET button. Horizontal (right-left)
airflow direction is adjusted manually, by moving the Air Flow Direction Louvers.
Whenever making horizontal airflow adjustments, start air conditioner operation and be sure that the vertical air direction
louvers are stopped.
R DANGER!
● Never place fingers or foreign objects in-
side the outlet ports, since the internal fan
operates at high speed and could cause
personal injury.
● Always use the remote control unit’s
SET button to adjust the vertical airflow
louvers. Attempting to move them
manually could result in improper
operation; in this case, stop operation
and restart. The louvers should begin
to operate properly again.
● During Cooling and Dry modes, do not
move the vertical air direcion louvers
outside their proper operating range
for the mode (1 - 3) and into the fan
region (4 - 7) ; using the louvers in
the fan region will cause moisture to
condense near the air outlet, and water
may drop onto the floor. During the
Cooling / Dry modes, if the louvers are
operated outside the range 1 - 3 for
more than 30 minutes, they will
automatically return to position 3
range.
● When used in a room with infants, chil-
dren, elderly or sick persons, the air
direction and room temperature
should be considered carefully when
making settings.
Vertical Air Direction Adjustment
Press the SET button (Fig. 6 O).
Each time the button is pressed, the air direction range will change as follows:
1 2 3 4 5 6 7
Types of Air flow Direction Setting:
1,2,3
: During Cooling / Dry modes
4,5,6,7 : During Heating mode
1,2,3,4,5,6,7 : During Fan mode
The remote Control Unit’s display does
not change.
● Use the air direction adjustments within the ranges shown above.
● The vertical airflow direction is set automatically as shown, in accordance with
the type of operation selected.
During Cooling / Dry / Fan mode : Horizontal flow 1
During Heating mode : Downward flow 7
● During AUTO mode operation, for the first minute after beginning operation,
airflow will be horizontal 1; the air direction cannot be adjusted during this period.
Right-Left Adjustment
Adjust the Right-Left louvers.
● Move the Right-Left louvers to adjust air flow in the direction you prefer.
knob
R DANGER!
● When adjusting the Right-Left Louvers, it
is necessary to stop the Air-Conditioner
first and make sure that it stops completely
before adjusting the direction.
knobs (three places)