Fantom Vacuum PT194H - Manual (Page 5)

OPERATING INSTRUCTIONS GETTING TO KNOW YOUR HAND HELD TRIMMER
WARNING: Always remove battery
before adjusting the blade cover.
The hand held trimmer can be
transformed from trimmer mode to
edging mode easily.
1. Grasp the blade cover on the hand
held trimmer and turn the handle of
the trimmer 180° counter clockwise.
(Fig. 8)
WARNING: To avoid serious
personal injury, be sure that the
battery pack is removed from unit
before cleaning or performing any kind
of maintenance on the unit.
Fig. 8
2. To use as an edging tool, keep
the protective blade guard in
direction of area being edged.
(Fig. 9)
Fig. 9
To remove blades:
1. Always remove the battery before
servicing your hand held trimmer.
2. Hold the blade hub with one
hand. With the other hand, hold
the blade and push in towards the
center of the
hub. (Fig. 10)
Repeat for
second blade
and dispose
of used blades
in normal
waste.
Changing the Blades
This hand held trimmer has two
blades, they must be changed at the
same time to ensure that the product
stays balanced. If your hand held
trimmer vibrates when in use, check
that both blades are worn evenly.
Adjusting the Blade Cover
Fig. 10
Fig. 11
Storage
3. Hold the new blade in the center
and place over the metal lug. Pull
away from the center of the blade
hub until you feel it snap into
place. (Fig. 11) Repeat for the
second blade.
1. Fully discharge the battery (by
running the unit) and then recharge
the battery for 10 hours.
2. Remove any build up of debris,
and wipe all exterior surfaces with
a dry lint free cloth.
3. Remove the battery and store in a
dry place, away from the reach of
children.
4. Always store the unit indoors to
prevent damage to the unit.
5. Once a month run the unit until
the battery is exhausted and then
immediately charge for at least 10
hours.
NOTE: It is not necessary to oil this
unit.
8. Charging Adapter
9. Ni Cd Battery
10. Charging Jack
11. Battery Compartment
12. Battery Release Buttons
13. Protective Blade Guard
14. Handle
1. Blade Cover
2. Blade (x 3 Sets)
3. Trigger Safety Interlock
4. On/Off Trigger
5. Charging Base
AD-0730-UL (8)
6. Charging Jack Receptacle
7. LED Charging Light
Illustrations may differ from actual product.
NOTE:
Hand held trimmer is shipped with the batteries
uncharged. Charging of the unit for 10 hours prior to
first use is required.
Technical Specifications
Voltage: 4.8 V DC
Power: 20 Watts
4 7