Faber PRO MAGNUMw - Manual (Page 7)

Version 12/04 - Page 7
0 1 0 1 0 1 2
L M V
Light On/Off Button ( L )
On/Off switch for the halogen lights. Move the switch to "1"
to turn the light ON and to "0" to turn it OFF.
Blower On/Off Button ( M )
On/Off switch for the blower. Move the switch to "1" to turn
the blower ON and to "0" to turn it OFF.
Blower Speed Button ( V )
Speed control for blower. Move the switch to position 1 for
LOW Speed, 2 for MEDIUM speed and 3 for HIGH speed.
For Best Results
Start the rangehood several minutes before cooking to develop
proper airflow. Allow the unit to operate for several minutes
after cooking is complete to clear all smoke and odors from
the kitchen.
Cleaning
The stainless steel grease filters should be cleaned frequently
in hot detergent solution or washed in the dishwasher. Clean
exterior surfaces with a commercially available stainless steel
cleaner. Abrasives and scouring agents can scratch stain-
less steel finishes and should not be used to clean finished
surfaces.
USE AND CARE INFORMATION
This rangehood system is designed to remove smoke, cooking
vapors and odors from the cooktop area.
Rangehood Control Panel
The control panel is located on the right-hand side under the
canopy. The position and function of each control button are
indicated in FIGURE 13.
FIGURE 13
WARRANTY & SERVICE
All Faber products are warranteed against any defect in materials or
workmanship for the original purchaser for a period of 1 year from the
date of original purchase. This warranty covers labor and replace-
ment parts. The warranty does not cover consumable parts such as
filters and light bulbs. This warranty does not apply if this product
has been subjected to faulty installation, misuse, or neglect. This
warranty excludes any consequential expense or damage resulting
from any use or malfunction of the product. All implied warranties
are limited to the duration of this warranty.
To obtain warranty service, contact the dealer from whom you pur-
chased the rangehood, or the local Faber distributor. If you cannot
identify a local Faber distributor, contact us at (508) 358-5353 for
the name of a distributor in your area.
WIRING DIAGRAM FOR 30" & 36" MODELS
Replacing the Halogen Lamps
Before you begin, make sure that the rangehood is turned
off and that the other lamps have had sufficient time to cool.
Halogen bulbs burn extremely hot and serious injury could
result from touching a hot bulb. To replace the lamp, the
bezel (A) around the lamp(C) must be removed as indicated
in FIGURE 14. This bezel (A) is held in place by two screws
(B). Remove the two screws and the bezel. Then remove
the lamp and replace with a new lamp. Once the new lamp
is in place, reinstall the bezel.
WIRING DIAGRAM FOR 48" MODEL
• This rangehood uses 20 watt Halogen Lamps.
FIGURE 14