FELLOWES PS75 - Manual (Page 2)

A
C
D
E
F
A
B
C
D
E
F
Operation
Cleaning
Sheet Capacity and Usage
• Do not exceed recommended sheet capacity for your model.
• Folding paper to fit the entry increases the thickness and recommended capacity may be exceeded.
• Clips and staples increase the thickness and may decrease sheet capacity.
3
DM-4
DM-6
DM-C
(without lights)
• Follow instructions for sheet capacity. (See Table A)
• Position paper over entry.
• Depress power switch to the ON (I) position to start cutting system.
• Return the power switch to the OFF (O) position to stop cutting system.
PS60
PS60CC
PS70
PS75
PS80
DM-C
(with lights)
• Follow instructions for sheet capacity. (See Table A)
• Depress the power switch to the ON (I) position to activate the standby
mode. *Green Ready light will come on.
• Shredder automatically starts when paper is placed in the entry and stops
when finished shredding.
• If the machine is not properly seated on the basket, the red light will come
on.
All Models
• Unplug the unit from the wall before cleaning.
• Housing can be cleaned with a cloth, dampened with a mild soap and water
solution.
US 20# Paper 64 GSM 80 GSM 80 GSM
Model: Sheets per Pass Sheets per Pass Sheets per Pass Sheets per Pass
120V/50Hz 100V/50Hz 230V/50Hz 240V/50Hz
PS60 12 14 12 12
PS70 12 14 12 12
PS75 12 14 12 12
DM-4 12 N/A N/A N/A
DM-6 12 N/A N/A N/A
PS60CC 7 9 7 7
PS80 7 9 7 7
DM-C 7 N/A N/A N/A
TABLE A Different paper weights and electrical currents will affect capacity.
Safety Instructions
• Read and save these instructions.
• Follow all warnings and instructions marked on the product.
• Always turn off and unplug the machine before moving, cleaning, or conduct other than normal
operation.
• Operate shredder from the power source indicated on the serial label. If you are not sure of the type of
power available, consult your dealer or a power company.
• Power cord should be easily accessible because it serves as the disconnect switch. If the power cord is
damaged, call the number listed under “ Contact for Service”.
• Keep loose objects (jewelry, ties, long hair) away from shredder.
• CAUTION: Do not insert aerosol cleaners or lubricants into or around the machine. Some agents may
combust, causing serious injury.
• Empty wastebasket frequently.
• Do not place shredder near water, over a radiator or a heat register.
• Do not rest anything on the power cord. Do not place machine where people will walk on the cord.
• The use of an extension cord is not recommended.
• Do not service this product yourself. An opened cover may expose you to dangerous voltage points or
other risks, and will void manufacturer’s warranty.
• Do not exceed recommended sheet capacity or usage. (See “Sheet Capacity and Usage”, Table A).
• Do not shred continuous forms.
• Do not shred labels, transparencies, glossy paper, newsprint, plastic or cardboard.
• Keep out of the reach of children and pets.
• Never insert your hand or fingers into feed opening.
• Practice caution when shredding paper that contains paper clips and staples. Shredder is intended for
paper only. Although clips and staples will not harm the cutting system nor void the 5 year cutter
warranty, the added thickness may decrease sheet capacity.
Installation
B
2
All Models
• Assemble basket (and stand, if applicable). See diagrams on page 38-39.
• Position shredder securely on basket.
• Plug power cord into a standard AC outlet with the appropriate power
requirements as stated on the serial number label adhered to the bottom
of the shredder.