Fisher FVH-E439 - Manual (Page 34)

PROGRAM TIMER RECORDING
Checking the Program Timer
1 Turn on the power (TV and VCR).
2 Set the TV to channel 3 or 4.
3 Press the MENU button.
The main MENU appears.
4 Press the SET button.
The programmed recordings are listed.
NOTE: To display the program type or rating, press
the TYPE button after selecting the desired program
using the CH/TRACK
l (or j ) button.
5 When finished, press the MENU button to exit the
menu.
6 Press the POWER button.
The VCR power turns off and the timer is set to the
recording standby mode.
The Timer icon (n) appears.
Clearing the Program Timer
1 Follow steps 1 – 4 in “Checking the Program Timer”.
2 Press the CH/TRACK l (or j ) button to select the
program to be cleared.
3 Press the CLEAR button.
The erase confirmation screen appears.
4 Press the CLEAR button again. (To cancel the erase
procedure, press the SET button.)
The selected timer program is erased from the
program memory.
5 When finished, press the MENU button to exit the
menu.
6 Press the POWER button.
Changing the Program Timer
1 Follow the steps under “Clearing the Program Timer”
to erase the program that you wish to change.
2 Follow the steps under “Timer Programming” to add a
new timer program.
Using Timer Recording for Several
Programs
If two or more programmed recording times overlap on
the same day, the VCR will not begin recording a new
program until the previous program has ended (as shown
below).
Program Recording Order
TIMER SETTING NOTES:
œ If the programmed recording falls on a Saturday or a
Sunday, the Daily recording mode will not be possible.
œ To select the A/V recording mode, press the INPUT
button instead of selecting a channel number.
œ 12:00 PM = noon; 12:00 AM = midnight.
œ If the end of the tape is reached during timer recording,
the VCR stops and the power turns off automatically.
œ If the power fails or the VCR is unplugged from the
AC outlet, the correct clock time and timer settings
are kept in memory for approximately 5 seconds.
After 5 seconds, the clock and program timer must
be reset when power is restored. Refer to INITIAL
SETUP to set the VCR.
Program
7:00PM
These portions will
not be recorded
10:00PM 8:00PM 9:00PM
SU4/UF2 (FVH-E439 GB) Tue. Feb. 09/1999
34