FUJITSU DESKPOWER 5000 - Manual (Page 46)

36
Replacing a internal hard disk equipped as standard
○ ○ ○ ○ ○ ○ ○
This section explains how to replace a standard-equipped internal hard disk with a hard disk of
larger capacity.
1
Set up the jumper switch.
See the manual accompanying the internal
hard disk and make sure that the jumper
switch has been set to master, or cable select.
2
If retaining metal brackets are mounted on
both sides of the internal hard disk to be
replaced, remove them.
Remove the screws (4) to remove the
retaining metal brackets.
3
Remove the upper cover.
4
Disconnect the hard disk cables.
Disconnect the power cord and flat cables
connected to the hard disk.
5
Remove the retaining metal bracket.
Remove the screw (one), then remove the
retaining metal bracket by sliding it in the
direction of arrow 1 , then arrow 2 , and then
lift it in the direction of arrow 3 .
2
1
3
08-Chap3(34-44) 25/4/00, 10:36 am 36