FUJITSU SPARC T5120 - Manual (Page 148)

122 SPARC Enterprise T5120 and T5220 Servers Service Manual • July 2009
6. If you are installing a new motherboard, install the following components:
a. All FB-DIMMs removed from the previous motherboard. Ensure that the
FB-DIMM modules are installed in the same memory configuration as they
were in before.
See “FB-DIMM Configuration Guidelines” on page 95 .
b. SCC module. See “SCC Module Overview” on page 114 .
7. Connect the hard drive data cables. For cable routing instructions, see
whichever of the following topics apply:
■ “Internal Cables for Onboard SAS Controller Cards in SPARC Enterprise T5120
Servers” on page 188
■ “Internal Cables for Onboard SAS Controller Cards in SPARC Enterprise T5220
Servers” on page 202
8. Install the air duct.
See “Install the Air Duct” on page 101
.
9. Reinstall the motherboard-to-power distribution board ribbon cable.
10. Reinstall the PCIe and XUAI risers.
See “Install a PCIe/XAUI Riser” on page 104 .
11. Install the top cover.
See “Install the Top Cover” on page 175 .
12. Install the server into the rack.
See “Reinstall the Server in the Rack” on page 176 .
13. Attach the power cables.
See “Connect Power Cords to the Server” on page 178 .
14. Power on the server.
See “Power On the Server Using the poweron Command” on page 179 or “Power
On the Server Using the Front Panel Power Button” on page 180 .
Related Information
■ “Remove the Motherboard Assembly” on page 118