FUJITSU SPARC T5120 - Manual (Page 78)

52 SPARC Enterprise T5120 and T5220 Servers Service Manual • July 2009
Note – In the ILOM shell there is no notification when the system is actually
powered off. Powering off takes about a minute. Use the show /HOST command to
determine if the host has powered off.
Related Information
■ “View the System Message Log Files” on page 49
■ “Display System Components” on page 51
■ “Enable System Components” on page 53
▼ Enable System Components
You enable a component by setting its component_state property to Enabled.
This removes the component from the ASR blacklist.
1. At the -> prompt, set the component_state property to Enabled.
2. Reset the server so that the ASR command takes effect.
Note – In the ILOM shell there is no notification when the system is actually
powered off. Powering off takes about a minute. Use the show /HOST command to
determine if the host has powered off.
Related Information
■ “View the System Message Log Files” on page 49
■ “Display System Components” on page 51
■ “Disable System Components” on page 52
-> start /SYS
Are you sure you want to start /SYS (y/n)? y
Starting /SYS
-> set /SYS/MB/CMP0/BR1/CH0/D0 component_state=Enabled
-> stop /SYS
Are you sure you want to stop /SYS (y/n)? y
Stopping /SYS
-> start /SYS
Are you sure you want to start /SYS (y/n)? y
Starting /SYS