Fortress Technologies FS-40 - Manual (Page 15)

15
TRANSMITTER PROGRAMMING
Note: Remotes Transmitters come pre-programmed from the Factory. When re-learning remotes or
adding remotes, ALL your system’s remote codes must be learned at time of programming!! This
system allow storage of up to 4 different remote codes in memory.
1. Turn key to the ON position. (Starting the vehicle is not necessary.)
2. Press Program/Valet button 4 times. After a few seconds, the unit will flash the parking lights 4 times.
3. Press Button #1 (Lock) of the transmitter to be learned. You should get 2 light flashes indicating the code-
learn. Now the unit is waiting for a 2 nd code, so repeat this step as needed with up to 3 additional remotes.
The unit will flash the lights in succession after each code learned for up to 4 codes. (2 flashes for the 2
nd
code, 3 flashes for the 3
rd
code etc.) If all 4 codes are learned, the unit will automatically exit code learning
mode, otherwise turn key OFF and close the hood.
IGN
OFF
WAIT FOR
4 FLASHES
PRESS 4X's
FLASH 2, 3, or 4 X's
IGN
OFF
PRESS LOCK BUTTON