Furuno 520 - Manual (Page 15)

2. BASIC OPERATION
2-5
2.4.2 Selecting the data shown on Data Display
Data Display may be set up to suit your operating needs as below.
Selecting data
In the STBY mode, you can select which data you want to display in the columns
shown in the figure below. For Normal Display 2, you may choose which data
you want to show on the analog indicator.
STBY 20.5
HDG 145.9
Data Display
Analog indicator column
STBY 20.5
HDG 145.9
Normal Display 2
Data column
1. Press the [STBY] key to show the STBY mode.
2. Press the [STBY] key several times to show the one of screens shown above,
which you want to change the data.
3. Press the course control knob.
4. For two data display, press the [PORT] or [STBD] key to select the column
desired.
5. Rotate the course control knob to select the data you want to show.
Available data and analog indicators are listed on the next page.
6. Press the course control knob to finish.