Faria Instruments Antares IS0250a User Manual
Page 22
20
FUEL MANAGER
STOP: Your fuel tanks must be activated and set to the proper capacity before the fuel
manager will become functional. Refer to Part II: SYSTEM SETUP for further
information.
It is CRITICAL that you correctly set the TOTAL AMOUNT OF FUEL each time you
refuel.
Total Amount of Fuel = Fuel Added + Fuel Remaining
Use the up or down navigation buttons to highlight the desired setting, then use the left or
right navigation buttons to change the value of the highlighted area. You can make
changes to all of the Fuel Manager options before saving.
Once all the changes have been properly set, press
. The
icon on the Save
Changes bar will automatically highlight. If your changes are correct, press
to
save.
will appear to confirm that changes have been saved. If the
changes are not correct, use the navigation pad to highlight
and press
.
will appear to confirm that the changes have not been saved.
Note: The TOTAL AMOUNT OF FUEL must be set to the proper value to insure
accurate performance from the Fuel Manager.