Fisher-Price PORTABLE ENTERTAINER 79070 - Manual (Page 4)

• Rotate the legs down.
• Make sure the treads on all four rubber feet are facing down.
If the treads on all four rubber feet are not facing down, you have
assembled the legs incorrectly. Remove the legs from the curved
tubes (press the buttons on the legs to release them from the
curved tubes) and re-read and repeat step 2.
• Place a base on a flat surface.
• While pressing the button on the side of the base, lift the frame to
the highest position. The button should be in the highest position.
• Repeat this procedure to raise the other frame on the other base to
its highest position.
• Make sure the button on each base is in the highest position.
IMPORTANT! Before each use or assembly, inspect this product for damaged hardware, loose joints, missing parts or sharp edges. Do not use if any
parts are missing or broken. Contact Fisher-Price® for replacement parts and instructions needed. Never substitute parts.
4
1
3
Frame
Base
Button Highest
Position
Lowest
Position
Leg Leg
• Position a leg so that the buttons are down and the treads on the
rubber feet face up.
• While pressing the buttons on the leg, insert and "snap" the ends
of the leg into the curved tubes on the base.
• Repeat this procedure to attach the other leg to the bases.
2
Treads Up
Leg
Curved
Tube Curved
Tube
This product contains small parts in
its unassembled state.
Adult assembly is required.
CAUTION
4
• Place the tray upright on a flat surface.
• Fit the caterpillar to the top of the tray. From the bottom of the
tray, insert three 5 /
8
" screws with washer heads through the tray and
into the caterpillar. Tighten the screws with a Phillips screwdriver.
Do not over-tighten.
• Slide the four rings onto the toy bar.
• Insert and "snap" the toy bar into the holes in the tray.
• Pull up on the toy bar to make sure it is secure.
Rings
Tray Hole
Hole
Toy Bar
Treads Down
Treads Down
ASSEMBLY
Caterpillar