Fostex VF-16 - Manual (Page 24)

24
4. Press the [ENTER/YES] key where the “Standard”
is flashed.
The format type selected is set and “Sure?” flashes.
5. Press the [ENTER/YES] key while the [RECORD]
key is depressed.
The formatting process is started. The formatting process
will take some time.
When the formatting is successfully completed,
“Completed!” will light up on the display.
Formatting the Hard disk
Carefully follow the instructions below to newly format the hard disk properly.
1. Turn ON the VF-16 after plugging the power cable
i n the electric outlet.
The VF-16 will startup. “Unformat!” will appear on the
LCD. The menu will automatically go to the SETUP mode.
The display showing the “Disk Format” menu appears.
2. Press the [ENTER/YES] key.
The drive selection display appears.
“IDE” will be flashed.
3. Press the [ENTER/YES] key where the “IDE” is
flashed.
The menu to select the format type appears.
“****” represents the name of the drive.
<CAUTION>
Either the “Standard” or “Quick” format type can be
selected. However, make sure that the “Standard”
format type is selected when formatting a newly
installed hard disk.
6. Press the [EXIT/NO] key (or [STOP] key) to escape
from the SETUP mode.
The Normal Display appears indicating the beginning of
the program (P01) that is automatically created after
formatting the hard disk.
flashing
flashing
<Normal Display>