FUJITSU F9600 - Manual (Page 16)

LinkPlus Interface Guide: Fujitsu F9600 Telephone System
PN: 1725-36134-001_E.doc 16
Note that the TYPE must be 3.
The other parameters in the brackets can be the default values.
Other related commands: CHA MLDT, DEL MLDT, DIS MLDT
Clear programmable buttons
The programmable buttons are probably assigned to a default button
pattern. Perform the following to clear all buttons (button 00 will not
be cleared since this is the prime-line button).
DEL MLPFB,[TNN:0],DN,ALL
Other related commands: ASS MLPFB, DIS MLPFB
Assign station name
If desired, use this command to assign a name to the extension.
ASS STNAM,[TNN:0],DN,NAME
Other related commands: CHA STNAM, DEL STNAM
Assign Features to Programmable Buttons
This assignment assigns selected features to selected buttons.
ASS MLPFB,[TNN;0],DNV,BNO,FN,[BNO,FN],,,,,,[BNO,FN]
The Fujitsu PBX will reset a phone after you assign a feature to a
programmable button. Therefore the phone will be unusable for
possibly as long as 20 seconds.
If Autodial is to be utilized, Autodial keys FAB10 (
FCN +4 ), FAB11
( FCN +5 ), FAB12 ( FCN +9 ), and FAB13 ( FCN +* ) must be programmed
for the Autodial feature. Additionally, the Program Mode feature
must be assigned to a desk set Feature Access Button that is mapped
to the handset (E.g. FAB14/
LINE +8 ). See the key-map diagram for
information about which Feature Access Button can be utilized for
Program Mode.