FELLOWES TB 100 - Manual (Page 2)

Equipment Parts
1. On\Off Switch
2. Ready Light
3. Binding Area
4. Cooling Stand
5. Binding Timer (TB 200 only)
Using the Binding
Machine
1. Turn On\Off switch to "On" position.
2. Machine is ready to bind when Ready Light
illuminates (approximately 1-2 minutes).
3. Using the table below, choose the correct thermal
cover based on the total number of sheets to be
bound:
Thermal Cover Size
# of Sheets Inches
mm
1-30 1\8" 3.2
31-60 1\4" 6
61-90 3\8" 9.5
91-120 1\2" 12.5
121-150 5\8" 15.5
151-180 3\4" 20
181-200 1" 25
4. Insert sheets into thermal cover. Be sure all
sheets are perfectly aligned and in contact with
glue strip.
5. Place document in Binding Area.
NOTE: Index portion of cover should be in
bottommost part of machine.
6. TB 100: Allow machine to bind document for 30-60
seconds.
TB 200: Press Binding Timer. Binding is complete
when Timer sounds. Turn off Timer by pressing
button.
7. Remove document from Binding Area. Gently tap
document on tabletop to complete the binding
cycle.
8. Allow finished document to cool vertically for 8-10
minutes by placing on Cooling Stand.
NOTE: Do not open finished document before
cooling cycle completes. Glue must adhere to all
pages.
Adding/Removing
Sheets from Bound
Document
Adding or removing pages from a bound document is
possible, but not recommended.
ADDING PAGES
1. Place sheets to be added at their required position
in the document.
2. Place document in Binding Area.
3. TB 100: Allow machine to bind document for 30-
60 seconds.
TB 200: Press Binding Timer. Binding is complete
when Timer sounds. Turn off Timer by pressing
button.
4. Remove document from Binding Area. Again, gently
tap document on tabletop to complete the binding
cycle.
5. Allow finished document to cool vertically for 8-10
minutes by placing on Cooling Stand.
NOTE: Do not open finished document before
cooling cycle completes. Glue must adhere to all
pages.
A
B
C
1
2
5
4
3
1
2
4
3