Fisher-Price CAMP BARBIE 74780 - Manual (Page 15)

15
• Turn the vehicle on its side.
• Fit a traction band around a wheel.
• Slide a slotted screwdriver under the traction band to
push the traction band onto the ridge in the center of the
wheel.
Helpful Hint: If the traction band is difficult to fit around
the wheel, you may want to soak it in warm water to soft-
en it slightly.
• Repeat this procedure to assemble a traction band to
each wheel.
Traction
Band
Wheel
Ridge
25
• Snap the center of the spark plug wire set onto the
pretend engine.
• Fit each of the spark plug wire ends into the holes on the
sides of the pretend engine.
Important Note! You must install your Power Wheels ® bat-
tery in your vehicle before assembling the pretend engine
under the hood. Please refer to “Battery Installation” on
page 16 for detailed instructions.
Please refer to the label placement diagram on the
enclosed label sheet to decorate your vehicle. Proper label
application will help to keep the labels looking their best!
Keep the following guidelines in mind when applying the
labels:
• Wash your hands before applying the labels.
• Before applying the labels, wipe the surface of the
vehicle with a clean, dry cloth to remove any dust or oils.
• Place the labels exactly as shown on the label sheet
diagrams.
• For best results, avoid repositioning a label once it has
been applied to the vehicle.
• After applying a label, rub the label firmly with a clean,
dry cloth to make sure the label is adhered to your vehi-
cle. Start at the center of a label and smooth towards the
outer edges to remove air bubbles.
Spark Plug
Wire Set
Spark Plug
Wire End
Hole
Pretend
Engine
26
27
Bottom View
Assembly