Falcon RACKMOUNT SG SERIES UPS PLUS SG1KRM-1TU User Manual
Page 9
7
8.
If unattended computer shutdown and monitoring are desired, connect the green
UPS/Computer cable to the DB-9 connector located on the UPS rear panel. Then
install the shutdown and monitoring software provided with the UPS. For your
reference, UNIX shutdown and monitoring software is available from Falcon Electric
at an additional cost.
9.
Verify the location selected has adequate ventilation to allow for the proper cooling
of the UPS.
DO NOT BLOCK UPS FANS OR AIR VENTS. THE UPS MUST NOT BE
INSTALLED IN AN ENCLOSED AREA.
11.
Plug the UPS power cord into the nearest grounded outlet.
12.
Turn the input circuit breaker located on the UPS front panel to the “on” position.
The internal UPS fan and front panel "line" indicator should turn on, followed by the
"bypass" LED, and after several seconds, the "inverter" LED.
13.
Turn on the connected equipment and verify the UPS does not go into overload by
observing the front panel load indicator LEDs.
14.
The UPS, should be plugged in and turned on for 24 hours to charge the batteries.
During this initial 24 hour charging period, battery backup time may be substantially
reduced.
TO TURN OFF THE UPS, SWITCH OFF THE INPUT CIRCUIT BREAKER
LOCATED ON THE UPS FRONT PANEL AND PRESS THE ON/OFF
BUTTON LOCATED ON THE UPS FRONT PANEL UNTIL THE UPS BEEPS.
THE UPS WILL RUN FOR ABOUT 30 SECONDS AND SHUTDOWN.
DO NOT PRESS THE ON/OFF BUTTON OR TURN THE CIRCUIT BREAKER ON
AGAIN DURING THE SHUTDOWN PROCESS OR THE UPS WILL GO TO AN
ALARM CONDITION, WARNING THAT THE UPS WAS NOT SHUTDOWN
PROPERLY.
SHOULD THIS OCCUR, TURN OFF THE INPUT CIRCUIT BREAKER AGAIN AND
WAIT UNTIL THE UPS SHUTS DOWN.
IMPORTANT
WARNING