First Alert FIRE THEFT SAFE 2054F - Manual (Page 5)

3
Home and Office Security Safes
6
Your Safe’s Unique Identification Numbers
When contacting Consumer Affairs, you should be prepared to supply some
important information that specifically identifies your safe. This information is
extremely important to assuring prom pt and accurate customer assistance.
It is strongly recommended that you identify and record the following information
in the “Safe Identification Record” form located on the inside back cover of this
manual:
Model Number
Serial Number
Key Number
Locating Model and Serial Numbers
Most First Alert ® safes include a small metallic silver or gray tag affixed to one
of the surfaces. This tag is usually located on the front or right side of the safe.
This tag contains the Serial Number, and on selected models a similar tag is
attached containing the Model Number. If a Model Number tag is not attached
to the safe, then it can be located on the front or side panel of the box that the
safe was packaged in. Write this number down for future reference.
Key Number
The Key Number is located on the key. If you do not have the key, the number
is also imprinted on the Emergency Override Key lock. See Emergency Override
Key, page 3, for instructions on locating this lock.
Important: DO NOT REMOVE TAGS!
In case your safe becomes inoperable or you lose your keys, these identification
numbers will be needed to correct the problem. It is recommended that the
number tags remain in place on the safe. If removal is necessary, then they
should be attached to the inside back cover of the Operation and Installation
Guide. Store in a safe and secure place for future reference.
Consumer Affairs Additional Features: Removable Shelves
Shelves
Removable Shelf (Model 2054F only)
To remove the shelf, simply lift it up and tilt it on a sufficient angle to provide
clearance for removal.
Adjustable & Removable Shelves (Model 2084F)
These models are designed with 5 position adjustable shelves to allow greater
flexibility and further accommodate your particular security storage needs.
To Install:
Your Shelf and Shelf Support Clips have been
shipped inside your safe and wrapped for protection
from damage during shipping.
1. Remove Shelf and (4) Shelf Support Clips
from protective wrapping.
2. Determine the desired position of your shelf
and note the corresponding Support Guide
Slots (2 on each side of interior walls) that
are best suited to support the shelf in that
position.
3. Install the (4) Shelf Support Clips in the same
position on all four support guides.
4. Install shelf into position by placing it inside
the safe (tilting if necessary) at a point above
the desired position.
5. Once inside, lower it into position until
resting on Shelf Support Clips.
To change the position of the shelf:
Simply remove the shelf and reposition the (4) shelf
support clips by sliding them up and out of the
support slots and reinstalling them into the new
positions. Then reinstall shelf as described above.
SUPPORT
GUIDES
Important: REMOVING SHELF
If you remove the shelf, it is strongly recommended that you DO NOT
DISCARD it. You may lay the shelf flat in the bottom of the safe to assure
full flexibility in the future.