Furuno FAX-408 - Manual (Page 14)

1. OPERATION
4
1.5.2 Selection of desired frequency, fine adjustment of frequency
Frequency may also be entered manually by pressing the FRQ key, and then entering frequency
by using the numeric keys and the REV/
z key (for entering decimal point). The available frequency
range is 2000.0 - 24999.9 kHz.
In the frequency display mode, use the S or T key to fine tune a frequency when in the frequency
display mode, in resolution of 0.1 kHz. When properly tuned, the center TUNE LED (green) lights.
If the upper TUNE LED (red) is lit, use the
S key, and if the lower TUNE LED (red) is lit, use the
T key.
1.6 Automatic Receiving
Once you choose the facsimile station from which to receive, the system goes into standby to
await the start signal from the facsimile station. Recording starts when the start signal is received.
1. Press the CH key to show the channel display.
2. Press the
S or T key to choose channel desired.
Note: Alternatively, you may enter the frequency of the broadcasting station by pressing the
FRQ key and entering frequency with the numeric keys and the REV/
z
key (for decimal point).
When the start signal is received, the message "AUTO START SEARCHING FRAME" appears
and the RCD LED (orange) flashes. Speed and IOC are automatically adjusted when recording
starts. The RCD LED lights during recording.
Note: The TUNE LED goes off when the RX level goes below a certain level or the equipment is
not receiving. Even if the TUNE LED goes off, the equipment records the fax signal as long as the
S/N ratio is suitable. Therefore, this is not a sign of TUNE LED trouble or equipment malfunction.
Stopping recording
Recording stops automatically when the stop signal is received. You may also stop the recording
manually by pressing the RCD key. The RCD LED goes off when recording is stopped.
C00* JMH 3622.5
S120 I576
* Asterisk indicates automatic
frequency selection.