FUJITSU SCANSNAP S300M - Manual (Page 15)

ScanSnap S300M Getting Started
14
■ Rear View
For the Document Specification, refer to "3.2 Paper Sizes of
Documents to be Scanned" in "ScanSnap S300M Operator's Guide"
stored in the ScanSnap Setup CD-ROM.
ATTENTION
The ScanSnap is turned on/off in conjunction with the connected
computer, or with opening/closing of the paper chute. Ordinary, you can
forget about turning on/off the ScanSnap.
USB connector
Connect a USB cable here.
Power connector
Connect either the Power cable or
USB bus power cable.
Security cable slot
You can plug a commercially available
security cable into this slot (anti-theft).
Adhesive label
Reminds you that the supplied
software has to be installed first.
After installing ScanSnap Manager
onto your computer, remove this
label to connect the ScanSnap to
your computer.