Fisher-Price P6584 - Manual (Page 15)

15
Problem Solution
Receiver signal L.E.D. flashes Receiver is out of range of transmitter. Move receiver closer
to transmitter.
Note: Range varies depending on surrounding conditions such
as noise levels, physical obstructions and signal interference.
Under optimal conditions, the range is up to 244 meters.
Transmitter power is off. Turn transmitter power on.
Loose power cord connection and transmitter power is off.
Check transmitter power cord plug-to-outlet connection.
No power to wall outlet and transmitter power is off. Make sure
light switch that controls power flow to wall outlet is on.
Power is off because circuit breaker for room is off. Make sure
house fuses and circuit breakers are on.
Receiver power/battery
L.E.D. does not light Receiver power is off. Turn receiver power on.
Batteries in receiver are weak or dead. Use AC adaptor as power
source and to charge the battery.
Power is off because circuit breaker for room is off. Make sure
house fuses and circuit breakers are on.
No power to wall outlet and power is off. Make sure light switch
that controls power flow to wall outlet is on.
Receiver power/battery
L.E.D. flashes Batteries in receiver are weak or dead. Use AC adaptor as power
source and to charge the battery.
Transmitter power L.E.D. does
not light Transmitter power is off. Turn transmitter power on.
Loose power cord connection and transmitter power is off.
Check transmitter power cord plug-to-outlet connection.
No power to wall outlet and transmitter power is off. Make sure
light switch that controls power flow to wall outlet is on.
Power is off because circuit breaker for baby’s room is off.
Make sure house fuses and circuit breakers are on.
You can hear conversations or
sounds from other homes There is signal interference due to other nursery monitors on
same channel or cordless telephone use. The monitor should
automatically find a new channel to avoid interference.
Receiver is not picking up
sounds from transmitter You may need to pair the receiver and transmitter. Turn over the
receiver and press the pairing button with a pen. Then, turn over
the transmitter and press the pairing button with a pen. The signal
L.E.D. on the receiver will flash and you will hear a tone.
Problems & Solutions