FELLOWES 200 - Manual (Page 6)

190
200
220
220 CC
Paper shredder
6 1.294.999.110 Edition 09/98
Switching equipment ON
(190 & 200 only)
– Press rocker switch to pos. (1)
• Controller switch locks in "on" position.
• Equipment is ready for operation
(standby).
– Feed paper
• The shredding process is started by
automatic start stop control in the paper
feed opening. Insert paper and
shredding begins automatically.
• When the shredding is complete, the
cutting system automatically stops
after approx. 3 seconds.
Switching equipment OFF
(190 & 200 only)
– Press rocker switch to pos. (3)
• switch resets to center position and
stops the cutting system.
Switching equipment ON
(220 series only)
– Press rocker switch to pos. (1)
• Switch locks in "on" position.
• Equipment is ready for operation
(standby).
• Green LED lights.
– Feed paper
• The shredding process is started by
photo–cells in the paper feed opening.
Insert paper and shredding begins
automatically.
• When the shredding is complete, the
cutting system automatically stops
after approx. 3 seconds.
Switching equipment OFF
(220 series only)
– Press rocker switch to pos. (3)
• switch resets to center position and the
machine is turned off.
5. Supplies
– Bags for cut material
(Packed in dispenser carton, 50 or 100 bags
to a roll depending on size. For bag informa-
tion, see label on inside of the waste container.
If label is missing, contact Fellowes or your
local Fellowes dealer for the stock number of
the bag that fits your machine.)
– Cutting block oil for cross-cut units
Stock # 35250.
6. Installation
– The paper shredder is supplied ready for
operation.
– Operate this product only from the type of
power source indicated on the marking label.
– Install the paper shredder so that the plug is
easily accessible.
– Shredder must be operated in upright position
only.
– Set up paper shredder so that the ventilation
slots are unobstructed. To ensure sufficient
ventilation of the shredder a minimum distance
of 4" (10 cm) to the wall or to the furniture must
be maintained.
7. Operation
Read operating instructions before
operating the shredder.
Insert plug in power outlet.
To avoid motor overload, the 190 and
200 model paper shredders may cut
out automatically after approx. 20
minutes of continuous operation.
1
USA
3
1
3