Fostex VC-8 - Manual (Page 4)

4
Model VC-8 Owner’s Manual
AD-12A ONLY
IN
OUT
WORD IN DIGITAL
OUT IN 5 4 3 2 1
5 4 3 2 1
ANALOG
7 6
7 6 8
8
12V
DC IN
OPTICAL
75
OFF ON
ANALOG INPUT MODE CLOCK DIGITAL MODE
ADAT/ANALOG CONVERTER
POWER
WORD
1-4 1-8 1-2 ON STBY INT(44.1k) OPTICAL
LOCKED
S/P DIF ADAT
OPTICAL
Names and Functions
WORD IN terminal switch
This must be switched ON
when the external WORD
clock is input.
ANALOG INPUT MODE switch
This switch is used to select the
channel to which the ADAT output
should be assigned for the signal
input to the ANALOG INPUT jack.
This switch will be active only when
the DIGITAL MODE switch is set to
ADAT. Refer to pages 6 and 7 for
details.
POWER switch/POWER LED
AC power to the VC-8 is switched
ON/OFF (or “standby”). If the VC-
8 is not to used for a long period,
t h e A C a d a p t o r s h o u l d b e
unplugged from the wall AC mains.
LOCKED LED
This indicates status
of the operating
clock selected by the
C L O C K s e l e c t o r
switch. Refer to page
6 for details.
CLOCK selector switch
The VC-8 operating clock (INT, WORD
or OPTICAL) is selected by this switch.
Refer to page 6 for details.
DIGITAL MODE selector switch
The DIGITAL MODE IN/OUT
formats (ADAT or S/P DIF) is
selected by this switch.
Refer to page 6 for details.
ANALOG INPUT connectors (1-8)
These are connected to BUS OUT
(or GROUP OUT) of the analog
mixer. Refer to pages 5 and 7 for
details.
DIGITAL INPUT/OUTPUT connectors
There are connected to the VR800
digital multitrack recorder or to the
DIGITAL IN/OUT connectors of a digital
recorder provided only with digital in/
out connectors.
DC IN jack (Center: Plus +)
The AC adaptor (AD-12A)
included with the VC-8 is
connected here. Do not use an
adaptor that is not soecified for
the VC-8.)
ANALOG OUTPUT connectors (1-8)
These are connected to the TAPE
INPUT jacks of the analog mixer.
Refer to pages 5 and 7 for details.
WORD IN connector (BNC)
The external WORD clock
signal is input here.
Refer to page 5 for details.