Fujitsu Siemens Computers Mini-Dock FPCPR25 - Manual (Page 6)

6
Installing the System into the Mini-Dock
1. Shut down the system by selecting Start> Shut Down>
Shut Down.
2. If a wireless module is installed in your system, remove
the right-hand support to accommodate the extra depth
(see Figure 4). To remove the support, slide it upwards
until it unlatches from the support platform.
3. Position the pen tablet against the positioning guide and
the back of the mini-dock.
4. Slide the pen tablet into the tray at the bottom of the
mini-dock and press it down firmly until it is seated, as
shown in Figure 4. The alignment guide in the bottom
of the tray ensures that the system is properly seated
over the connector.
5. Re-start your system.
C A U T I O N S
■ Dropping conductive material onto the charging
contacts could result in internal damage to the pen
tablet circuitry.
■ Prior to installing your pen tablet into the mini-dock, be
sure to power down your system first. Failure to do so
could result in damage to the system or mini-dock.
minidock.fm Page 6 Tuesday, August 21, 2001 3:30 PM