Fluke FLK-TI-SBC3 User Manual

Flk-ti-sbc3, Charging base/power supply with adapters, Instruction sheet

Advertising
background image

FLK-TI-SBC3

Charging Base/Power Supply with Adapters

Instruction Sheet

The Fluke FLK-TI-SBC3 Charging Base/Power Supply with Adapters charges the Fluke

FLK-TI-SBP3 Smart Battery Pack for Thermal Imagers. The FLK-TI-SBC3 consists of a

charging base, power supply, and power outlet adapters.

PN 3481481 August 2009

© 2009 Fluke Corporation. All rights reserved. Printed in USA.
All product names are trademarks of their respective companies. Specifications are subject to change without notice.

Safety Information

Use the FLK-TI-SBC3 only as specified in this instruction sheet or other Fluke

product-specific manual. See Table 1 for a list of symbols used on the FLK-TI-SBC3.

A

Warning identifies hazardous conditions and actions that could cause bodily harm or

death.

A

Caution identifies conditions and actions that could damage the Imager or cause

permanent loss of data.

W

Warning

To avoid injury:

Do not disassemble or short circuit the battery pack.

Do not expose the battery pack to temperatures above 50 °C (122 °F).

Do not incinerate or mutilate the battery pack.

Use only ac adapters approved by Fluke for the product to charge the battery or

power the product.

Table 1. Symbols

Symbol

Description

P

Conforms to requirements of European Union and European Free Trade Association.

"

Imager connected to battery charger.

;

Conforms to relevant Australian standards.

)

Conforms to relevant Canadian and US standards

W

Important information. See manual.

~

Do not dispose of this product as unsorted municipal waste. Go to Fluke’s website for

recycling information.

Charging the Battery

Before using the battery pack for the first time, charge the battery in the two-bay charging

base for at least two and one-half hours. For complete charging instructions, see the “Ti32,

TiR32 Thermal Imagers User Manual.”

Specifications

See Table 2 for the specifications.

Table 2. Specifications

Battery Charging

10-15 Vdc 2 A or charge battery pack in Imager with included ac

adapter rated: 100-240 Vac 50/60 Hz, 15 V 2 A.

Charging / Power LED

Status

Charging LED

Power LED

off

no battery detected

no dc power input

solid green

charged

dc power present

blinking green

charging

na

blinking red

fault

na

Dimensions

159.5 mm x 68.9 mm x 51.3 mm (6.28 in x 2.71 in x 2.02 in)

Operating Temperature

-10 °C to 70 °C (-14 °F to 158 °F)

Storage Temperature

-20 °C to 80 °C (-4 °F to 176 °F) without batteries

Humidity Range

10 % to 95 % non-condensing

PO

WER

Ti SBC3

SMA

RT

BA

TTER

Y

CHARGER

3

Advertising
This manual is related to the following products: