Fujitsu Siemens Computers V17-1 - Manual (Page 55)

A26361-K961-Z100-1-5E19, edition 2 47
Other functions
To use Channel up/down on the unit control panel as function buttons
●
When you press MENU to go into OSD, CH up/down will become the up/down function control
buttons.
To use -VOL+ as level control buttons
●
When you press MENU to go into the sub control bar, then the level can be adjusted by the
VOL+ buttons.
To use -VOL+ as Mute control buttons
●
When you press both VOL+ and VOL- buttons on the upper control panel simultaneously, the
sound will be muted.
● If you need to switch on the sound again, then either press MUTE button on the remote control
unit or press any VOL+ or VOL- button on the remote control unit or on the LCDTV itself.
Aspect button (Screen Aspect Ratio)
ARC - Aspect Ratio Control
● *Normal: This sets the aspect ration to 4:3 for traditional TV programmes. There will be black
bars at either side of the screen.
● *Panscan: Expands 4:3 video sources to fit the 16:9 screen by magnifying the image at the
edges of the screen. This creates less distortion at the center of the screen.
● *Zoom: Some DVD movies may not fill the top and bottom of the screen. The zoom function
extends the height to fill the screen.
● *Full: This mode expands the width of 4:3 video sources evenly to fill the 16:9 screen. There
will be distortion at the center of the screen as well as the edges.
APC control button (Automatic Picture Control)
●
Press APC button on the remote control repeatedly to cycle through the APC settings. These
settings are Normal, Clear or Dark. For example, when the screen is showing night scene or
darker screen, you can use APC to change the screen to Clear and get a brighter picture. If the
screen is too bright, you can use this APC button to change the screen to Normal or Dark.