Furuno FAR-2167DS-BB - Manual (Page 15)

1-7
1.2 Monitor Unit
The monitor unit is can flush mounted in a panel or mounted on a desktop (requires optional
accessories).
The FAR-2167DS-BB is not equipped with a monitor unit. Procure a suitable monitor unit locally.
Recommended monitor: SXGA (1280×1024), aspect ratio 5:4.
For MU-190, see the applicable Operator’s Manual.
Mounting considerations
When selecting a mounting location, keep in mind the following points:
• Select a location where the screen can be viewed conveniently while facing the bow.
• Locate the unit out of direct sunlight and away from heat sources because of heat that can build
up inside the cabinet.
• Locate the unit away from places subject to water splash and rain.
• Leave sufficient space on the sides and rear of the unit to facilitate maintenance, referring to the
outline drawing for maintenance space.
• The monitor unit will give interference to a magnetic compass if it is placed too close to the com-
pass. Observe the compass safe distances on page ii to prevent interference to the compass.
Mounting procedure
Flush mounting
Follow the procedure below to mount the monitor unit in a console.
1. Make a cutout in the mounting location referring to the outline drawing shown below.
2. Set the monitor unit to the hole and fix it with four self-tapping screws (6×30).
3. Attach panel hooks near the fixing holes (upper part). See next page. These are used to pull
out the monitor unit from the panel for servicing.
4. Attach four panel covers to the fixing holes.
Mounting dimensions for flush mounting the monitor unit
(79)
454
506
534
4- φ 8
FIXING HOLES
490
420
4-FIXING HOLES
30 80
506 1
296
1
1
296
1