Meridian Audio 565 - Manual (Page 31)

Configuring the digital surround processor
27
To select a 5.1 LFE subwoofer
If you have the 7.1 version of the 565 you can add an LFE
subwoofer to layouts that do not normally have one (such as G,
L, or M), or choose an LFE subwoofer instead of a mono
subwoofer in layouts that have a subwoofer (such as A).
● Press
> or < until you see a
display such as:
LFE 5.1 Sub
● Press A or V to change the 5.1 Sub option.
With layouts with no subwoofer the choice is between No 5.1
Sub or LFE 5.1 Sub. For layouts with one or more subwoofers
you can choose between Mono 5.1 Sub, to give a standard THX
80Hz crossover, or LFE 5.1 Sub, to give an 120Hz crossover.
To set other configuration options
The other configuration options are generally set to an
appropriate value when you reset the 565 to one of the standard
settings, and you should not normally need to alter them; see
Choosing standard settings, page 20.
These options are summarised in the table opposite for
advanced use:
Option Initial value
Crossover frequency
Xover 84Hz
24 Bit Upgrade
24 Bit? Y
Communications mode (500 Comms
or 200 Comms)
500 Comms
Controller mode (Auto Setup,
Controller, or Not Con.)
Auto Setup
System address (1–8)
Sys.Addr. =1
Product address (1–8)
Prod.Addr.=1
Volume mode (Main Volume or
2nd Volume)
Main Volume
Front panel volume (N or Y)
FP Volume? N