Fantom Vacuum FM740 - Manual (Page 14)

1
2
3
4
5
Agitator Assembly
Motor Shaft
Flat Belt
Motor Shaft
Flat Belt
Flat Belt
Pulley
REPL A CEMENT INSTRUCTIONS
Caut ion: Be sure to turn the ON/OFF switch to the "OFF " position and disconnect the
power cord from the wall outlet before replacing any of the parts below.
REPL AC ING THE FL AT BE LT
Remove the bottom plate.
(refer to page 15)
Lift out the agitator assembly,and then remove the flat belt from the motor shaft and
the agitator pulley.
Place a new flat belt onto the motor shaft and pulley.
Holding two ends of the agitator to place the agitator assembly into the grooves by in the
nozzle head, making sure that the new flat belt slides securely into the guide.
Caution:
Install the flat belt so that it has
no twists in it, and so that all
components turn smoothly.
Reattach the bottom plate
(refer to page 15)
13
Brush Holder
Groove