FRIGIDAIRE 700 Series - Manual (Page 4)

4
Operating Instructions
Vent Latch
Delay Start
Allows you to delay starting the POTS & PANS
cycle up to 6 hours.
•
Turn dial to select number of hours.
• Press MAIN CYCLES pad.
• Select HI-TEMP WASH ON option and other
desired options.
• Close door to latch. The DELAY START light
will come on.
Plate Warmer
For warming dishes and serving plates before
serving hot foods:
• Load clean plates and dishes to be warmed.
• Turn dial to PLATE WARMER.
• Select HEAT DRY ON option.
Very Important
Information—
Read Before
Operating Your Dishwasher!
Normal Operating
Sounds
This dishwasher does not sound like most
dishwashers—IT’S QUIETER.
Your Precision Wash System
® dishwasher uses
energy efficient motors for the wash and drain
portions of the cycle you select. Each cycle has a
series of water fills and drains for washing and
rinsing dishes. As each cycle begins, you may–or
may not–hear the drain motor.
The next sound you will hear is the splashing
water as it enters the tub. Then the lower arm
rotates and circulates water. This is followed by a
pause and a slightly different sound as the
middle arm sprays water. If you listen closely,
you will hear the change in sound as the wash
action switches from one arm to the other.
PLEASE BE ADVISED: If you compare this
dishwasher to previous models, you may be
surprised at what you DON’T hear!
Getting Started
1. Load dishwasher (See Preparing and Loading
Dishes).
2. Add detergent (See Dishwasher Dispenser &
Detergents).
3. Add rinse aid, if needed (See Rinse Aid).
4. Select desired CYCLE (See Cycle Chart). The
indicator will show red when selected.
5. Turn dial clockwise to select cycle or number of
hours for delay start.
Status Indicator Lights
(available select models)
When DELAY START option is selected, the Delay
Start light will glow as timer counts down to begin
cycle.
The HEATING DELAY light means the cycle is
being extended to heat water to proper
temperature in the main wash or final rinse, based
on options selected.
CLEAN light comes on when a cycle is complete.
To turn it off, turn dial slightly until light goes off.
6. Select desired energy OPTIONS (See Energy
Options). The indicator will show red when
selected.
7. If using DELAY START, go to step number 9.
8. Run hot water faucet nearest dishwasher until
water is hot. Turn water off.
9. To start, close door to latch.
Appearance may vary from your model.