Fujitsu Siemens Computers Standard Jumper Cable / Network Cable without jumper Siemens S7 300 - Manual (Page 5)

Series HMI Connection Manual
2. PLC Ethernet Setting
Simatic (V5.4)：
1. Right click on “CP343-1 Lean” module and select "Object Properties", on this page set up “IP
address” and “Subnet mask” for CP343-1 Lean Module. Please be aware that the “IP
address” setting must be the same as PLC Ethernet setting in Screen Editor and the “Subnet
mask” setting must be the same as the HMI Ethernet setting in Screen Editor.
2. To add a new "Other station", right click on “Object Properties", add a new Interface and set
the “Type” as “Industrial Ethernet”. To set up HMI “IP address” and “Subnet mask”, go to
“Ethernet interface" > "Properties", please be aware that this setting must be the same as the
HMI Ethernet setting in Screen Editor. As the setting is completed, left click on the green box
above “Other station” and drag to link with the green line above.
V1.02 Revision January, 2012
207