Fujitsu Siemens Computers 19T2 - Manual (Page 15)

Color monitor 19T2
A26361-K616-Z100-2-5E19 English - 7
1 2 1 = Power connector
2 = Data cable
Ê Be sure that the monitor and the system unit are switched off.
!
The system unit's power plug must be pulled out!
Ê Connect the connector of the data cable to the (active) monitor port on the system unit and
secure the plug-in connection by tightening the safety screws.
i
If your system unit has two monitor ports ("onboard" screen controller and separate
graphics card), the monitor port for the separate graphics card is usually active.
Ê Plug the power cable supplied into the power connector (1) of the monitor.
Ê Plug the power connector of the monitor into a properly grounded power outlet.
Ê Plug the power connector of the system unit into a properly grounded power outlet.
i
When you start working with your monitor for the first time you should install the
appropriate graphics drivers for your application software. Details of how to do this are
provided in the documentation on your screen controller/the associated driver software.