Fortinet 2 SXRC - Manual (Page 34)

34
SXRC Remote Control
Opera
tion
phase MENU - Here is where you can switch the polarity of
each channel(s) output between 0 or 180 degrees.
Use the UP and DOWN keys to scroll
through both chns , left chn and right
chn then press the ENT key to select. SX.1
Series does not offer Left or Right Channel
option...Only 0 Degree or 180 Degree for the entire amplifier
since it is a Mono-Block design. Skip this step and move to
next paragraph.
Use the UP or DOWN keys to select from
0 degree or 180 degree . Press the ESC
key to save your setting and return to the
both chns , left chn and right chn
options menu. You can now select another
phase option to adjust on this amplifier if desired.
Does not apply to SX.1 Series. Pressing the ESC key at this
point on a SX.1 Series amplifier exits the PHASE menu.
When you are done adjusting the phase on
this amplifier press the
ESC key while in the
Both chns , left chn and right chn
options menu to return to the AMP ADJ menu
and choose another function to adjust.
NOTE:
While you are in the PHASE menu the
PHASE indicator on the ISIS display is lit.
This indicates you are making adjustments
in the PHASE menu.
HOME ENT ESC
HOME ENT ESC
HOME ENT ESC
b b o t t h h c c h h n n s s
SYS
MEM-1
GAIN GAIN EQ LPF HPF KOMP
AMP1
LOCK
MEM-2 MEM-3 MEM-4
PHASE
MUTE
AMP2
LEFT LEFT RIGHT RIGHT
There is also a LEFT and RIGHT indicator
in the ISIS display that will light up
indicating which channel(s) (Left and/or
Right) are currently being adjusted.
By default, all channels in all amplifiers ares set to 0 Degree.
e e 0 0 d d e e g g r r e e
SYS
MEM-1
GAIN GAIN EQ LPF HPF KOMP
AMP1
LOCK
MEM-2 MEM-3 MEM-4
PHASE
MUTE
AMP2
LEFT LEFT RIGHT RIGHT