Fisher-Price 79029 - Manual (Page 12)

FCC Note
(United States Only)
Note: This equipment has been tested and found to comply with
the limits for a Class B digital device, pursuant to
Part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and can
radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interfer-
ence to radio communications. However, there is no guarantee
that interference will not occur in a particular installation. If this
equipment does cause harmful interference to radio or televi-
sion reception, which can be determined by turning the equip-
ment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment
and receiver.
• Consult the dealer or an experienced radio/TV technician
for help.
Note: Changes or modifications not expressly approved by the
manufacturer responsible for compliance could void the user‘s
authority to operate the equipment.
Care
The pad is machine washable. Wash the pad separately in cold
water on the gentle cycle. Do not use bleach. Tumble dry
separately on low heat and remove promptly. The frame, seat
base, seat ring and toys may be wiped clean using a mild clean-
ing solution and a damp cloth. Do not immerse the frame.
Fisher-Price, Inc., a subsidiary of Mattel, Inc., East Aurora, NY 14052 U.S.A.
©2003 Mattel, Inc. All Rights Reserved. ® and ™ designate U.S. trademarks of Mattel, Inc.
Printed in Mexico 79029b-0920
Remove Seat and Pad
• Push the seat lock but-
tons under each upper rail
(you will have to do this
one at a time), and slide
the seat base off of the upper rails.
• Turn the seat base over so the the bottom faces you.
• While pressing near any notch on the seat ring, pull the seat
ring from the seat base.
• Remove the pad from the seat ring.
Replace the Seat Base, Seat and Pad
• Please follow the Assembly instructions on pages 6, 7 and 8,
steps 12 through 17.
PUSH PUSH