Furuno CSH-7 - Manual (Page 43)

8-2
Breaker ON/OFF state
ON
OFF
Breaker
DOWN command LED (Red)
POWER ON/OFF LED (Green)
Hand crank
Shaft gear
Motor gear
8A
Cable gland
POWER
switch
Breaker
(Bottom view)
How to use the hand crank
1. Turn off the POWER switch on the hull unit.
2. Remove gear cover.
3. Attach hand crank to shaft gear or motor gear.
Hand crank
Shaft gear
Tighten screw.
(Use screw from
cover.)
Shaft moves 600 mm
per 120 turns of crank.
Motor gear
Tighten screws.
(Use screw from
cover.)
Shaft moves 600 mm
per 210 turns of crank.
a) When crank is attached to shaft gear
(Requires greater force but less turns.)
b) When crank is attached to motor gear
(Requires less force but more turns.)
Figure 8-1 How to use the hand crank
CAUTION
POSSIBILITY OF INJURY
1. If breaker (hull unit) trips do the
following:
1) Turn off power swich on hull unit.
2) Wait 60 sec after breaker has tripped.
3) Press breaker.
2. Turn off hull unit before using hand
crank.