Faria Instruments Speedometer/Depth Sounder - Manual (Page 5)

Miles
Nautical Miles
calibration adjusted using the sub menus.
Pressing and holding the “Mode” button
while the Trip Log is displayed will
change the display to the “settings” menu
(see Figure 2, page 6).
Trip Log “Settings” Menu
There are three items in the Trip Log
“Settings” Menu: Reset, Units, and
Calibration. Briefly pressing the “Mode”
button cycles through the menu items.
The microprocessor will automatically
record the new settings as you adjust
them.
Reset
Pressing the “Up” and “Down” button
resets the Trip Log to zero.
Units
Pressing the “Up” or “Down” button
cycles the units of measurement for the
Trip Log between miles (MI) and nautical
miles (NM).
Calibration
This menu item is used to simultaneously
adjust the calibration of the Speedometer
and the Trip Log. Two methods of
calibration are possible. These methods
will discussed in the Calibration Section.
Depth Sounder
The Depth Sounder displays the depth of
the water under the boat.
The depth can be displayed in feet, meters,
or fathoms. Audible and visual alarms can
be set to warn of shallow or deep water
conditions. A “keel offset” setting allows
the operator to adjust for the difference in
the location of the Depth Sounder
transducer compared to the deepest part of
the boat’s hull. The various settings are
accessed by pressing and holding the
“Mode” button while the Depth Sounder
is displayed (see Figure 2, page 6).
Page 3