Fantom Vacuum CW233H - Manual (Page 6)

Filter
Cartridge
Locking
Knob
Fig. 13
Fig. 9
ASSEMBLING THE CADDY
Assemble the Vacuum to the Caddy
1. Make sure that the hose intake is facing forwards
and the wheels are at the rear of the unit. Using the
handles on the canister, carefully lower it onto the
frame aligning the canister edge with the notches in
the frame. (Fig. 6)
2. To attach the canister to the handle supports, align
the canister brackets on each side of canister with
the supports. (Fig. 7)
3. With the clamp assembly tabs facing downwards,
slide a clamp assembly onto the right and left
caddy support. (Fig. 7)
4. Place the clamp assembly tabs onto the canister
brackets on each side of the canister.
5. Tighten the clamp assembly by turning the hand nut
clockwise until it is secured on the supports. (Fig. 8)
Filter Assembly
This wet/dry vacuum requires different filter assembly
for wet or dry pick-up. The filter cartridge and dust bag
are required for dry pick-up. (Fig. 10) The foam filter is
required for wet pick-up. (Fig. 11)
Fig. 12
4
Fig. 6
Notches on Caddy
Notches Notches
Fig. 7
Clamp
Assembly
Tabs
Canister Bracket
6. To insert the caddy handle onto the right and left
caddy supports, fit the ends of the caddy handle
into the openings of the left and right caddy supports
and push down until the caddy handle clicks into
place. (Fig. 9)
Fig. 8
Hand Nut
Filter Cartridge Dust Bag Foam Filter
Fig. 10
Dry Pick-UP Wet Pick-UP
Fig. 11
For Dry Pick-Up
Warning:
To reduce risk of
electric shock - unplug before
cleaning, assembly or emptying
canister.
1.
To assemble the filter for
dry pick up, turn the filter
holder upside down on a
level surface. (Fig. 12)
2. Place the filter cartridge
onto the filter holder,
ensuring that the locking tab
inside the filter cartridge is
aligned with the slot on the
filter holder and turn the
locking knob until it stops.
(Fig. 13)
Important : Do not operate
the vacuum without the filter
cartridge and dust bag in
place for dry pick-up