FUJITSU fi-4120C2 - Manual (Page 107)

6.5 Multi feed Detection Conditions
fi-4120C2 Image Scanner Operator’s Guide 91
ADF AND PAPER SPECIFICATI
O
N
6
6.5 Multi feed Detection Conditions
There are three multi feed detection modes: document thickness, document length, and both docu-
ment thickness and length. The following conditions must be satisfied in each of these detection
modes.
■ Detection by Document Thickness
Sheets of the same thickness shall be set in the ADF at a time.
• Document thickness: 0.065 to 0.15mm
• Printed area: 12% or less
• No black printed areas are allowed at the center area (26 x 10mm) at the leading edge of the
document.
• Punched holes are not allowed within 35mm of the vertical center line of the document.
• The deviation in the amount of the light transmitted through background areas must not be
less than 10%.
■ Detection by Document Length
Sheets of the same length shall be set in the ADF at a time.
• Document length deviation: 1% or less
• Punched holes are not allowed within 35mm of the vertical center line of the document.
■ Detection by Document Thickness and Length
Sheets of the same thickness and length shall be set in the ADF at a time.
• Document thickness: 0.065 to 0.15mm
• Document length deviation: 1% or less
• Printed area: 12% or less
• No black printed areas are allowed at the center area (26 x 10mm) at the leading edge of the
document.
• Punched holes are not allowed within 35mm of the vertical center line of the document.
• The deviation in the amount of the light transmitted through background areas must not be
less than 10%.