To delete a cod key – FUJITSU M Server M5000 User Manual
Page 21
Capacity on Demand (COD) Administration
9
3. Verify that the key was added to the COD database:
The key you add should be listed in the output. See
.
4. Save the key in a safe place where you can refer to it if the XCP configuration
is reset, the COD database is lost, or some other event requires you to reinstall
it.
Note – Do not attempt to install the same COD key more than once, except as noted
in
. Doing so would be a contract violation.
▼ To Delete a COD Key
Before deleting a key from the COD database, the XSCF firmware determines
whether a sufficient number of active COD CPUs are available, plus headroom. If all
activated COD CPUs are in use and no headroom is available, the operation fails.
You can force the operation by using the -f option in
, below, but doing so
will overcommit any COD CPU reservations that might be in effect.
1. Log in to the XSCF console with platadm privileges.
2. Verify that you have enough COD permits or headroom to cover COD resources
currently in use.
Use the showcodactivation command as described in
. If you do not have sufficient COD permits or headroom to
compensate, power off one or more domains or disconnect the appropriate
number of boards.
3. Delete the key from the COD database:
4. Verify that the key was removed from the COD database:
The key that you deleted should not be listed in the output. See
.
XSCF> addcodactivation -r
XSCF> deletecodactivation
key
XSCF> deletecodactivation -r