Ferris Industries Derby Stallion 1846198 - Manual

Installation
Instructions
Derby Stallion Weight Mount Kit
Part No. 1846198
This kit is required when using the Triple Bag
Collector #1693501 and Hitch & Tube Kit
#1693791 grass collection system.
WARNING
Before beginning any service work turn off the
PTO, set the parking brake, turn off the ignition,
and disconnect the spark plug wire(s).
1 © Copyright 2000 Ferris Industries. All Rights Reserved.
INSTALLATION
1. Park machine on a flat, level surface and engage the
parking brake.
2. Measure and mark the front main frame tubes to the
dimensions shown in Figure 1. (1-1/4” down from the
top of the tube, 3/4” in from the end of the tube.)
3. Using a 3/8” drill bit, drill one (1) hole in each of the
main frame tubes from the outside surface of the
tube.
4. Slide the weight mount rack into the main frame
tubes and align with the holes drilled through the
frame (see Figure 2). It may require you drive the
arms into the frame tubes using a wooden block and
hammer.
5. Finish drilling through the opposite wall of the frame
tubes using the weight rack as a guide.
6. Install the 3/8” bolts and nuts and fasten securely.
7. Install the weight plates supplied with the grass col-
lector on the weight mount rack (see Figure 3).
8. Install the weight retainer rod through the weight
mount rack and secure with the hairpin clips (see
Figure 3).
9. Reinstall the spark plug wires.
Figure 1. Hole Location
Figure 2. Weight Rack Installation
Figure 3. Weight & Retainer Rod Installation
3/4”
1-1/4”
Kit Contents:
Part No. Qty. Descrpition
1846169
1 Stallion Weight Mount Rack
1846174 1 Weight Retainer Rod
N/A 2 Hairpin Clip
N/A 2 Bolt, 3/8-16 x 2”
N/A 2 Nut, 3/8-16 Nylon Lock
1846262
Rev. 3/2001
TP 200-7014-01-SL-D
For all Derby Stallion ZT2354 mowers