Kenwood JK60 - Manual (Page 6)

key
ቢ lid
ባ on/off switch
ቤ neon light
ብ water level gauge
ቦ scale filter
ቧ 2 cups
ቨ 2 spoons
ቩ dual voltage selector
ቪ cord clip
to use your travel jug kettle
1 Remove the cups and spoons from
the kettle.
2 Select the required voltage by
turning the selector control
ቩ.
Always check that you have
selected the correct voltage
before using the kettle.
3 Fill it through the spout or lid. The
water level must be between “MAX”
and “MIN” (1 cup/approx. 200mls).
4 Check the lid is closed.
5 Plug in and switch on. The neon will
come on.
6 Your kettle will boil and switch off
automatically. To re-boil, wait a few
seconds - the on/off switch needs
time to reset.
7 Always unplug the kettle after use.
● Take care when using the cups and
do not overfill above the inner rim
(approx. 200mls).
● Your kettle is fitted with a scale filter
to hold back limescale particles.
● If you find drops of water under your
kettle, don’t worry - it is just
condensation.
boil-dry protection
● If you switch on with too little water,
your kettle will cut out automatically.
Switch off and let it cool down
before re-filling. When it has cooled
down, the switch will reset itself.
approximate boiling times
220/240 volts approx 5 minutes for
450 mls (maximum)
110/120 volts approx 5 minutes 40
seconds for 450 mls (maximum)
care and cleaning
● Before cleaning, unplug your kettle
and let it cool down.
● The cups and spoons can be placed
in the kettle for compact storage.
● Wrap the cord around the kettle and
secure using the cord clip
ቪ.
the outside
● Wipe with a damp cloth, then dry.
Do not use abrasives - they will
scratch the plastic surfaces.
the inside
● Wipe with bicarbonate of soda on a
damp cloth. Rinse thoroughly.
● Even though your kettle comes with
a scale filter, you still need to clean
the inside (and the filter) regularly.
3