First Act FI3002 User Manual

Important safety instructions

background image

Congratulations on your new electronic guitar!
Please read this guide carefully before you begin playing.


Rock-It GuItaR


1) Infra-Red Strum


2) Whammy Bar

3) Built-in Speaker

4) Rhythm Keys

(Rock 1, Jazz 1,

Rock 2, Jazz 2)

5) Demo Key

6) Tempo Keys

(T1, T2, T3)

7) Reset (Stop)

8) Volume Control

customer assistance
Phone: 888.551.1115
Email: [email protected]

First Act, First Act Discovery, and the
First Act Discovery logo are trademarks
of First Act Inc.
©2008 First Act Inc.
All rights reserved.









BefoRe you play


Batteries required: 3 x “AA” size (not included)
To ReplaCe BaTTeRIeS

1. Open the battery compartment cover, position the batteries in the

compartment and make sure that (+) & (-) are in the correct position.

2. To ensure proper safety and operation, batteries must always be

replaced by an adult. Never let a child use this product unless the

battery door is secured.

3. Keep batteries away from small children. Immediately and safely

dispose of all used batteries.

1. Do not mix old and new batteries.

2. Do not mix alkaline, standard (carbon zinc) or rechargeable (Nickel

– Cadmium) batteries.

3. Only the same or equivalent types of batteries are recommended.

4. Non rechargeable batteries are not to be recharged.

5. Rechargeable batteries are to be removed from the product before

being charged.

6. Rechargeable batteries are only to be charged under adult


7. Exhausted batteries are to be removed from the product.

HoW To play


To activate guitar, press any of the rhythm keys or the demo key.

DeMo Key

Press the demo key to hear one of the 4 rhythms (rock 1, jazz 1, rock 2,

jazz 2). Press the demo key again to switch to the next rhythm.

Do not cover the infrared control, or the rhythm will be interrupted.


Press any of the rhythm keys to play one of 4 rhythms (Rock 1, Jazz 1,

Rock 2, Jazz 2).

TeMpo KeyS

Press and hold down the T1, T2, or T3 keys to change to a different

tempo while you’re playing a rhythm.

ReSeT Key

The reset key stops the rhythm or demo.

InfRaReD STRuM ConTRol

To play the rhythm by infrared control, activate the guitar, then wave

your hand like you are strumming in the center of the guitar between

the two red lights. Each time you strum, some notes will play. Keep

strumming to play the whole rhythm!

VoluMe ConTRol

Turn the volume dial to control the music volume.


Press the whammy bar downward to play a whammy lick.

ImpoRtant Safety InStRuctIonS

Please read this section carefully.

1. Read and follow these instructions.

2. Do not use this device near water.

3. Clean only with a dry cloth.

4. Do not use near any heat sources such as radiators, heaters,

or stoves.

5. Only use the attachments/accessories specified by the


6. Refer all servicing to qualified service personnel. Servicing is

required when the drum pad has been damaged in any way, liquid

has been spilled onto the drum pad, the drum pad has been

exposed to rain or moisture, does not operate normally, or has

been dropped.


1. Do not change the parts without professional instructions. Any

change may cause malfunctions.

2. When the guitar is not in use for a long period of time, remove

the batteries to avoid battery corrosion.
3. Keep the wrapping bag out of the reach of children to avoid a

choking hazard.

4. Always move the guitar carefully to avoid damage to outer

covering and inner components.

5. The guitar should not come in contact with acid or alkali. It

should not be operated where there is corrosive or excessively

moist air around to avoid corrosion of the electrical contacts.

note: This equipment has been tested and found to comply with

the limits for a Class B digital device, pursuant to Part 15 of the FCC

Rules. These limits are designed to provide reasonable protection

against harmful interference in a residential installation. This

equipment generates, uses, and can radiate radio frequency energy

and, if not installed and used in accordance with the instructions,

may cause harmful interference to radio communications. However,

there is no guarantee that interference will not occur in a particular

installation. If this equipment does cause harmful interference to

radio or television reception, which can be determined by turning the

equipment off and on, the user is encouraged to try to correct the

interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet or a circuit different

from that to which the receiver is connected.

- Consult the dealer or an experienced radio TV technician

for help.

Warning: Changes or modifications to this unit not expressly approved

by the party responsible for compliance could void the user’s authority

to operate the equipment.