Fisher & Paykel DCS DD224P5 - Manual (Page 20)

18
SINGLE MODELS
US CA
Cavity preparation
Cavity
Important!
Be sure the edges of the services hole are smooth or covered. If the service hole is through a metal partition
the hole must be protected with the Edge Protector supplied to prevent damage to the power cord or hoses.
These marks indicate mounting tab screw locations
Note: To align drawer front to adjacent cabinetry, the product to counter top clearance can be
increased to 1⁄8”
( 3 mm).
Preferred position. If adequate clearance, services hole can be higher.
If hole is higher, ensure drain hose(s) are routed straight into the waste connection.
90 o 2” x 4”
Note: S
ervices can be loca
ted
either side of DishDr
awer®.
Important!
Adjacent cabinetry must not
extend above cavity base
Clamp (1) Wire clip (1) Phillips 16 mm
screws (5) Drain hose
support (1) Drain hose
joiner (1) Washer (1) Edge Protector (1)
(if service hole
partition is metal)
110-120 VAC
max. 15 A
min. 7 7⁄8 ”
(200 mm)
3⁄8”
(10 mm)
max. 17 11⁄16 ”
(450 mm)
max. ø 1 ½ ” (38 mm)
If the Drain hose(s) supplied are not long enough to reach your services, you must use a Drain Hose Extension Kit
P/N 525798 which will extend the drain hose(s) by 3.6m. The kit is available from the nearest DCS
Authorized Service Agent, or by phone: 1-888-281-5698, or www.dcsappliances.com. DO NOT extend beyond this limit.
Moisture
protection
tape must
be applied.
If no side partition,
use a brace for
securing.
Moisture protection
tape (1)
(to prevent
moisture damage)
* *
*
Side flexible extrusions (2)