Safety – Kenwood JK630 User Manual

Page 5

Advertising
background image

safety

●

Avoid contact with steam coming
out of the spout area when pouring
and out of the lid when refilling.

●

Keep small children away from the
kettle and never let the cord hang
down over the worktop edge - a
child could grab it and pull the kettle
down. If you don’t need so much
cord, shorten it. See ‘before
plugging in’ below. Cordless models:
push excess cord inside the
powerbase.

●

Always unplug your kettle

when not in use.

●

Never overfill - boiling water may
splash out.

●

Never put the kettle, powerbase,
cord or plug in liquid.

●

Do not use if there is any damage
to the kettle, powerbase, cord or
plug. Get it checked or repaired: see
‘service’.

●

This kettle is not intended for use by
young children or infirm persons
without supervision.

●

Young children should be supervised
to ensure they do not play with the
appliance.

●

Caution: Do not operate the kettle
on an inclined surface.

●

Cordless models: only use the
powerbase supplied and keep it
clean and dry.

●

Make sure the lid is secure before
switching the kettle on.

●

Warning: Do not open the lid while
the water is boiling.

●

Take care when opening the lid -
droplets of hot water may be
ejected.

●

Make sure the kettle is switched off
before lifting or pouring.

●

Cordless models: remove from the
base before filling or pouring.
Corded models: unplug the cord
from the kettle before filling or
pouring.

●

Never put the kettle near or on
cooker hot plates or gas burners.

●

This kettle is for boiling water only.

●

This kettle is for domestic use only.

●

Failure to observe these cautions
may result in damage to the kettle.

before plugging in

●

Make sure your electricity supply is
the same as the one shown on the
underside of your kettle.

●

This kettle complies with European
Economic Community Directive
89/336/EEC.

before using for the first time

●

Remove all packaging and any
labels.

●

Fill to ‘MAX’, boil, then pour the
water away.

key

ቢ lid catch
ባ water level gauge
ቤ on/off switch with neon
ብ powerbase (JK750 series only)

with multiposition cord exits

ቦ compartment for excess cord
ቧ scale filter

to use your jug kettle

1 Fill it through the spout or lid. To

open the lid, pull back the catch.
The water level must be between
‘MAX’ and ‘MIN’.

●

Be economical: do not boil more
water than you need.

●

To improve the quality of your drinks
always use fresh water.

●

Empty the kettle after each use.

2 Check the lid is closed.
3 Plug in and switch on. The neon will

come on.

4 Your kettle will boil and switch off

automatically. To re-boil, wait a few
seconds - the on/off switch needs
time to reset.

●

Your kettle is fitted with a scale filter
to hold back limescale particles.

●

If you find drops of water under your
kettle, don’t worry - it is just
condensation.

2

Advertising