Furuno FR-8122 - Manual (Page 30)

3. SETTING UP THE EQUIPMENT
3-2
3.2 Opening the Installation Menu
After you have installed the equipment, set it up as follows.
1. Press the MENU key. The main menu appears on the screen.
2. Rotate the trackball downward to choose Installation. The installation menu appears in
gray to right side of the screen.
3. While pressing down the CANCEL/HL OFF key, press the MENU key five times to
activate the Installation menu.
[ENTER]: Enter [CANCEL/HL OFF]: Back
[MENU]: Exit
System
GPS
Mark
Custom 1
Custom 2
Custom 3
Target
ARP
AIS
Tuning
Type
View Position
Input Source
Language
Purpose
Antenna Height
Heading Adjust
: Center
: Main
: 5 m
: 0
°
: 8062
: English
: Sea
Tuning Initial Adjust
Manual MBS Adjust
Auto Installation Setup**
Manual Timing Adjust
Local Time Offset
: 0
: - 0.1 H
: 0
Menu Installation
Initial
Factory
Sector Blank 1**
Installation
Total TX Time* : 000000.5 h
Total On Time* : 000000.6 h
* : Displayed when scrolled.
Memory Clear*
** : Set the Section Blank to "Off" in order to
execute Auto Installation Setup in the
Installation menu.
GPS Buoy
Video Initial Adjust : 0
Antenna Rotation : Rotate
4. Press the ENTER key. The highlighted cursor appears in the Installation menu.
5. Rotate the trackball downward or upward to choose an item in the Installation menu.
6. Press the ENTER key to show setting window.
7. Rotate the trackball downward or upward to choose an option.
8. Press the ENTER key to confirm setting.
9. Finally, press the MENU key to close the main menu.
Basic Settings
Language: Choose an appropriate language.
Purpose: Choose the purpose of this radar among River, Sea and IEC. The default setting
is Sea.
River: To use this radar on a river.
Sea: To use this radar on high seas.
IEC: To use this radar as the type approved radar.
Type: Choose type of this radar among 8062 (6 kW radar), 8122 (12 kW radar) and 8252
(25 kW radar) to agree with the specifications of the antenna unit. The default setting
is 8062. Unsuitable setting may result in malfunction.