Kenwood SJ900 - Manual (Page 5)

safety
● Always use the filter and never
overfill - boiling water may splash
out.
● Avoid contact with steam coming
out of the spout area when pouring
and out of the lid when refilling.
● Beware: the metal body of the kettle
will get hot during operation.
● Keep small children away from the
kettle and never let the cord hang
down over the worktop edge - a
child could grab it and pull the kettle
down.
● If you do not need so much cord,
shorten it by winding any excess
cord inside the powerbase
ቧ.
● Always unplug your kettle
when not in use.
● Never put the kettle, powerbase,
cord or plug in liquid.
● Do not use if there is any damage
to the kettle, powerbase, cord or
plug. Get it checked or repaired: see
‘service’.
● This kettle is not intended for use by
young children or infirm persons
without supervision.
● Young children should be supervised
to ensure they do not play with the
appliance.
● Caution: Do not operate the kettle
on an inclined surface.
● Only use the powerbase supplied
and keep it clean and dry.
● Make sure the lid is secure before
switching the kettle on.
● Warning: Do not remove the lid
while the water is boiling.
● Make sure the kettle is switched off
before lifting or pouring.
● Remove the kettle from the base
before filling or pouring.
● Never put the kettle near or on
cooker hot plates or gas burners.
● This kettle is for boiling water only.
● This kettle is for domestic use only.
● Failure to observe these cautions
may result in damage to the kettle.
before plugging in
● Make sure your electricity supply is
the same as the one shown on the
underside of your kettle.
● This kettle complies with European
Economic Community Directive
89/336/EEC.
before using for the first time
● Remove all packaging and any
labels.
● Adjust the length of the cord - pull
the cord out of the base to lengthen.
To shorten the cord turn the handle
on the underside of the powerbase
clockwise.
● Fill to ‘MAX’, boil, then pour the
water away. Repeat 2 to 3 times.
know your Kenwood jug
kettle
ቢ lid
ባ scale filter
ቤ water level gauges
ብ on/off switch with neon
ቦ 360˚ powerbase
ቧ cord winder handle
to use your jug kettle
1 Fill the kettle through the lid. The
water level must be between 'Max'
and 200ml (1 cup).
● Always use the filter and never
overfill - boiling water may splash
out.
● Be economical: do not boil more
water than you need.
● To improve the quality of your drinks
always use fresh water.
● Empty the kettle after each use.
2 Check the lid is closed.
3 Plug in and switch on. The neon will
come on.
4 Your kettle will boil and switch off
automatically. To re-boil, wait a few
seconds - the on/off switch needs
time to reset.
2
English