FUJITSU D1522 - Manual (Page 42)

Error messages
A26361-D1522-Z120-3-6319 English - 31
System battery is dead - Replace and run SETUP
Replace the lithium battery on the mainboard and redo the settings in the BIOS Setup .
System Cache Error - Cache disabled
Switch the device off and on again. If the message is still displayed, please contact your sales
outlet or customer service centre.
System CMOS checksum bad - - Default configuration used
Call the BIOS Setup and correct the previously made entries or set the default entries.
System Management Configuration changed or Problem occurred
A system fan or system sensor has failed. Check the hardware operation.
System timer error
Switch the device off and on again. If the message is still displayed, please contact your sales
outlet or customer service centre.
Uncorrectable ECC DRAM error
DRAM Parity error
Unknown PCI error
Switch the device off and on again. If the message is still displayed, please contact your sales
outlet or customer service centre.
Verify CPU frequency selection in Setup
The frequency setting for the processor is invalid. Correct the BIOS Setup and the setting.
DOS error messages
This chapter contains the error messages that occur while DOS is running.
If a uncorrectable error occurs while DOS is running, then the following error text is output on the
screen:
Critical error logged to server management processor - system halted
If the NMI button of the control panel is pressed, then the following error text is output on the screen:
Frontpanel NMI activated - system halted