English, Safety – Kenwood CM650 User Manual

Page 5

Advertising
background image

safety

Never let the cord hang down over
the worktop edge - a child could
grab it and pull the machine down.
Push excess cord inside the back of
the machine.

Always make sure there is water in
the tank before switching on.

Never use a damaged coffee maker.
Get it checked or repaired: See
‘service’.

Never put the machine in water or let
the cord or plug get wet.

Watch out for steam and never
touch the hotplate.

This machine is for domestic use
only.

This machine is not intended for use
by young children or infirm persons
without supervision.

Don’t let children play with this
machine.

before plugging in

Make sure your electricity supply is
the same as the one shown on the
underside of your machine.

This machine complies with
European Economic Community
Directive 89/336/EEC.

before using for the first time

1 Remove all packaging.
2 Wash the parts: see ‘care and

cleaning’.

3. Push excess cord inside the back of

the machine.

4. Run two lots of water through the

machine (without coffee) to clean it
out. Fill the tank to the top cup mark
when you do this. See ‘to make
coffee’.

key

ቢ hotplate
ባ compartment for excess cord
ቤ filter door release button
ብ permanent coffee filter (or use a

paper filter instead)

ቦ filter holder
ቧ filter door
ቨ on/off switch with indicator light

(model CM650 only)
additional features on the

CM660

ቩ strength control indicator light
ቪ strength control button
ቫ auto/on/off indicator light
ቭ auto/on/off button
ቮ automatic timer light
ቯ automatic timer button
ተ hour button
ቱ minute button

to set the clock (model

CM660 only)

(the clock does not have to be set in
order for the coffee maker to
operate)

1 Plug into the power supply.
2 Press the hour and minute buttons

until the correct time is shown. Make
sure when selecting the hour that
AM or PM is correctly selected.

Providing the appliance remains
connected to the power supply the
clock will keep the correct time, if it
is unplugged the clock will flash
12:00.

to make coffee

1 Pour water into the tank. The water

must be between the top and
bottom cup marks. Then close the
lid.

Use cold water. We recommend
using filtered water from a Kenwood
Water Filter as it reduces limescale.
Never use warm or fizzy water.

If you use the jug to fill the tank, look
at the tank marks, not the jug marks.
They’re slightly different to allow for
the fact that some of the water gets

2

English

Please unfold the front page illustrations

Advertising
This manual is related to the following products: