Kenwood CM470 series - Manual (Page 7)

3 To set the clock press the on/off
button or wait 1 minute for it to
automatically set.
● To re-adjust the clock at any time,
press and hold the clock button for
5 seconds and adjust the clock as
above.
Note – the backlight of the display
will automatically turn off after 1
minute.
to program automatic brew
1 Set the clock to the correct time (see
‘to set the clock’).
2 Press the program button, the clock
symbol and the display will flash.
3 Press the clock button until the
desired brewing time is displayed
(follow procedure in ‘to set the
clock’).
4 Press the on/off button to confirm
the automatic time selected. (The
display panel and the on/off indicator
light will flash).
5 Press the program button to return
to the current time of day (the on/off
button will continue to flash). The
brewing cycle will begin once the set
time is reached and the on/off
button will stop flashing.
● If you want to check the automatic
time selected, press the program
button.
● To override the automatic brewing
operation press the on/off button
and the coffee maker will start
immediately. Press the button again
to switch off.
care & cleaning
● Always switch off, unplug and allow
to cool before cleaning.
● Never put the machine in water or let
the cord or plug get wet.
● Don’t wash parts in the dishwasher.
water filter
● Change and discard the water filter
after 70 brewing operations or within
a calender month whichever is
sooner.
carafe, lid, permanent filter,
filter holder, water filter
holder
● Wash, then dry.
body
● Wipe with a damp cloth, then dry.
Don’t use abrasives - they’ll scratch
the plastic and metal surfaces.
descaling
With use, the display will indicate
when the coffee maker requires
descaling. A series of solid lines will
gradually appear and when 4 appear
in the display and flash
, the
coffee maker has completed 100
cycles or more and requires
descaling (see ‘to descale’).
important
When descaling always remove the
water filter and water filter holder
first.
to descale
1 Buy a suitable descaler.
2 Descale the machine.
3 After descaling, run several lots of
water through the machine to clean
it out. Fill the tank to the top cup
mark when you do this.
4 Wash the parts.
5 To reset the descale counter to zero,
press the clock and program button
at the same time for 2 seconds.
service
● If the cord is damaged it must, for
safety reasons, be replaced by
Kenwood or an authorised Kenwood
repairer.
If you need help with:
● using your machine or
● servicing, spare parts or repairs
Contact the shop where you bought
your machine.
4